One of the first things many people do with their Raspberry Pis is to set up an XMBC media center. That must habe an other reason.Raspberry Pi Hacks (2014) Chapter 5. I do not know if it's only because it is a "B" and not a B+ that solve this probel (but normally it should happen to the analog output and not on the HDMI output)? Hello, i have got some "scrash" sound when playing tv, i was thinking that it was related to the analog part, but even if i put the sound by hdmi i got this "crap" sound, it hapen some times, not always etc. Here is the command i have to put in //rc.suspend: In fact i think that we should unmount before. Hub-ctrl -h 0 -P 3 -p 1 => The key turn on. Hub-ctrl -h 0 -P 3 -p 0 => It turn off power of the key layer n Set the video render layer number (higher numbers are on top) key-config Uses key bindings specified in instead of the default fps n Set fps of video where timestamps are not present orientation n Set orientation of video (0, 90, 180 or 270) threshold n Amount of buffered data required to come out of buffering in seconds video_queue n Size of video input queue in MB audio_queue n Size of audio input queue in MB video_fifo n Size of video output fifo in MB audio_fifo n Size of audio output fifo in seconds win "x1 y1 x2 y2" Set position of video window lines n number of lines to accommodate in the subtitle buffer no-ghost-box no semitransparent boxes behind subtitles align left/center subtitle alignment (default: left) font-size size font size as thousandths of screen height italic-font path (default: /usr/share/fonts/truetype/freefont/FreeSansOblique.ttf) (default: /usr/share/fonts/truetype/freefont/FreeSans.ttf) subtitles path external subtitles in UTF-8 srt format no-osd do not display status information on screen amp n Set initial amplification in millibels (default 0) vol n Set initial volume in millibels (default 0) no-boost-on-downmix don't boost volume when downmixing Ignored if file is not seekable, start position applied if given r / -refresh adjust framerate/resolution to video ![]() z / -nohdmiclocksync do not adjust display refresh rate to match video y / -hdmiclocksync adjust display refresh rate to match video (default) ![]() 3 / -3d mode switch tv into 3d mode (e.g. o / -adev device audio out device : e.g. n / -aidx index audio stream index : e.g. In fact, the short jump is on the 1 and 3 key, you could test, you have got big jump in left and right, and short jump in 1 and 3.Īnd perhaps we should put the sound lower on launch. And there is no way to make shorter jumps, without compile the omxplayer myself. I will test the volume part by me self, to see how I must change the mplayer plugin to get the correct keys.īy the way: You must use the omxplayer.sh to check the key binding that is used by the plugin. You could invers the 1/3 key with left and right too because by default left and right are fast jump, not lot low jump.Īnd to play a video fast jump is to fast. ![]() You could test it again, perhaps i have made something wrong. Has i said, i have already change the key to + and - in the config file, and it has changed nothing. For the pi, just the command line à said is enouth to change the governor. Ok, i will try this package, even if it's not needed. Some questions on MLD on pi (From non German speaker!)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |